MultiSync MT1035 Manuel d'utilisateur télécharger pdf (Page 15)

E-15

Using A Tabletop Or Cart

1. Place your LCD projector on a flat level surface at the

optimal distance from the screen or wall so you realize the

size image you want. (Avoid having bright room lighting or

sun light directly on the screen or wall where you'll be

projecting the image.)

2. Connect the power cable, remove the lens cap and turn the

projector on. (If no input signal is available, the projector will

display a background image.)

3. Ensure that the projector is square to the screen.

4. Move the projector left or right to center the image horizon-

tally on the screen. (A)

5. To center the image vertically (B), lift the front edge of the

projector and press the buttons on the front of the projector,

just above the feet, to release the one-touch tilt feet. (There is

approximately 10.5˚ of up and down adjustment for the front

of the projector. )

6. If a trapezoidal distortion appears on the screen, use the

KEYSTONE button on the remote control or select Key-

stone from the menu to correct the distortion.

If necessary, adjust the front or rear feet so that the lens

surface is parallel to the screen. If you use the projector with

the screen tilted, the picture will be distorted. Each of the rear

feet height can be changed up to 4 mm.

7. Increase or reduce the size of the projected image by press-

ing the "Zoom" (+) or (–) buttons on the remote control or

top of the cabinet.

(A) Top view

(B) Side view

screen

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 45 46

Pas de commentaire

MultiSync MT1035 Manuel d'utilisateur Page 15